Monaco 2008 Knight Owner's Manual download pdf (Page 129)

125

2008 KNIGHT

WATER SYSTEMS — 6

Fresh Water Fill

When connecting the motorhome to fresh

water, use a hose manufactured and labeled

“for potable water.” This ensures that the hose

will not avor the water. It is recommended to

install a pressure regulator on the water line. On

hot days the hose may expand and burst from

excessive pressure within the hose.

1. If the motorhome has the

optional Power Hose Reel,

pull hose out. Connect

one end of the pressure

regulator to the water

source and the other end

to the hose and go to step

#3. If motorhome does not

have the optional power

hose reel, proceed with

step 2.

2. Connect one end of the

pressure regulator to the

water source and

the other end to the

potable hose.

3. Connect potable hose

to the City/Fresh

Water Fill valve.

4. Open the water pump

shut-off valve.

5. Make sure the fresh

water tank drain valve is in the

closed position.

6. Turn the water control handle to the

“Tank Fill” position.

7. Turn on water at the water source. The

water should be audible as the fresh

water tank lls. Observe tank ll by

using monitor panel located inside the

motorhome, or the (optional) monitor

panel located in the roadside water

service center.

8. Frequently press the “Test” switch

and read the scale as the fresh water

tank lls. Do not leave the motorhome

unattended while lling the fresh water

tank.

9. The tank is nearing full when the light

marked “F” illuminates. When the tank

is completely full, water will ow out

an overow tube under the motorhome.

10. Turn off water supply and return the

water control handle to “City Water”

position.

11. Disconnect the potable hose. Remove

pressure regulator. Store the hose with

both ends connected to prevent debris

from entering the hose.

12. If applicable, activate the (optional)

power hose reel switch to coil the hose

on the reel. Attach plug to keep debris

and insects out.

WATER TANK - FRESH GRAVITY FILL

The gravity ll inlet allows uids to be

introduced directly into the fresh water tank.

When dry camping, water can be poured directly

from a container into the fresh water tank. The

gravity ll inlet can be used to pour disinfecting

solution into the fresh water tank. Use only

potable water sources, solutions and delivery

systems when using the gravity ll inlet.

Filling the Tank:

1. Unscrew ll cap taking care

to keep cap and inlet clean.

2. Insert potable water hose

into inlet.

3. Fill tank until water over-

ows from inlet.

NOTE

DO NOT leave the

gravity fill inlet

unattended when in use.

City Water Hook-up

When connecting the motorhome to fresh

waste, use a hose manufactured and labeled for

potable water to ensure the hose will not avor

the water. It is recommended to install a pressure

regulator on the water line to prevent the hose

from expanding and bursting due to excessive

pressure.

1. If the motorhome has an optional

hose reel, pull hose out. Connect the

pressure regulator to the water source

and the other end to the hose and

proceed to #4.

2. Install the pressure regulator on the

water source.

3. Connect the pressure regulator to the

potable hose and the potable hose to the

City/Fresh Water Fill Valve.

4. Water control valve should be in the

“City Water” position.

040480y

040460o

040406

Located in the

roadside water

service center

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 245 246

Monaco 2008 Knight Owner's Manual Page 129

Comments to this Manuals